bit of an eoi im not sure if i should sell complete or seperate
Sbc dart shp block
All components are forged lunati crank rods
Cp pistons works out 358ci all new items
Balanced new sfi approved balancer
Milidon oil pump pick and custom asr oil pan rear mount for torana or holden
Full arp stud kit mains and heads
Compression ratio 11.8 :1
Hydraulic roller camshaft billet comp cams .600 lift around 280 duration will run on pump gas
Brodix alloy heads ported flow over 300cfm all new stainless valves full race prep new pac springs retainers
Csr electric water pump
All new timing chain set
Yella terra shaft mount rockers
3/8 trend pushrods
Heads are off for inspection needs lifters(does come with johnson lifters but couple need replacing) to finish and heads and manifold installed
New Victor high rise manifold minor porting and port matched to heads
I have 17/8 4 into 1 custom extractors and modified crossmember for lh/x torana that can come with for the right $
Im going back to the holden motor
Should make 500+hp with the right carby
Im located in redcliffe 4020
Im open to offers atm