10WHK
casual poster

Heading to the Nats with a mate and his car and I’m seriously thinkn about tryn to finish this thing and take it down for a skid, plenty of time just...

Rings and big end bearings ordered, nearly finished porting 2nd head all exhaust ports done just a couple inlets to go then off to my engine bloke...

Has anybody used the crow solid roller lifters in standard lifter bores Cam only has low lift for a SR and the lifters being half the price of...

Plus use a big drill with plenty of torque

Tungsten tip is the go, tool steel didn’t cut as nice and was way slower

Engine builder made them for me for free I just gave him the valves, took about an hour and a half to do all pistons I took mine 100th down and 050th...

That’s sounds like the same thing I’m doing to my hz wags, iv been looking at the same cam but the motor I got came with a fairly big cam already ...

Luke from LCF Fabrications has been doing the mini tubs, commodore pursuit rims tucked in nice and close, hopefully far enough so it doesnt smash...