46Crab
casual poster

Smitty, I looked through some of the older HPE Pete's and TK's build threads but couldn't find it. Plus since photobucket has dropped its guts none...

Ahhh... 3/8 NPT rings a bell. Thanks mate, I'll grab some plugs and give that a go.

Are these 1 5/8" primary or 1 3/4"?

Are they building you an engine or heads?

Cheers, I'll give that a go.

Who did the machine work for you? Are you assembling the engine yourself?

As a part of fitting the 4 bolt mains caps to your engine it should have had the mains line bored. Your machinist should be telling you the...

Looks grouse

What cam did you stick in this engine CNCDAVO?

For a street car I'd go with rubber, less vibration etc. (lower NVH levels) For a pure strip weapon the tuff mounts would be ok.

Does this 'GST' now apply to all imports regardless of cost? Taxes used to only be over $900-1000... Thanks Harvey Norman...

Deuce, I used a very simple comp calculator (it doesn't even take head gasket bore diameter into consideration) and simply plugged in the numbers...

You could simply use a .050" head gasket, that would pull about .3 compression out of it....

Thanks Rod.

Did these heads you flowed come complete (valves and springs) from Edelbrock? Just wondering what the springs and valves were like? Thanks

TK, I know this is an old thread, but was this an off the shelf cam or a custom grind? Would it work ok with VN efi heads? A mate wants to do a...

It's missing 2 things... they are both cylinders... Sent from my iPhone using Tapatalk

I reckon you should be able get the Crane 24533 Hydraulic Roller lifters for $1200-1250 if you shop around. Lots of places have them listed for...

Try Crankshaft Rebuilders in Melbourne. They make cranks and are a lot more user friendly than another Melb company that was getting cranks made... ...