Help ... having trouble bridging amp.
Details : 4ch amp trying to bridge to run 2 x 10" subs from 4ch bridged to 2ch. Amp shows where to bridge chanels in series, but the protection LED flashes and gives no output? Tried wiring the chanels in parallel but same prob - protection LED flashes and no output?
Info : Amp = Specifications:
Powervox 4 Channel Car Amplifier
Output power (Max): 5600W (1400W x 4)
Output power (RMS): 560W (140W x 4)
Frequency response: 10Hz - 20KHz ± 1dB
Input sensitivity: < 250mv
Signal / Noise ratio: 98 dB
Separation scale: > 45dB
Stereo output: 2 - 16 Ω
Bridge output: 4 - 16 Ω
Power supply: 12V
Info : Sub Features:
10"x2 SUBWOOFER
P.P CONE FOAM EDGE
40 OZ MAGNET
4-LAYERS VOICE COIL(AL): 2"
MAX POWER: 2000W
FREQ.RESP.: 35-300HZ
IMPEDANCE: 4 OHM
SPL: 93dB/W/M
Weight: 18Kg
Dimension: 72(L)x 34(W)x 35 (H)
A picture ...
